Interference Statement - Acer 7100 Series User Manual

Appendix
FCC Class B Radio Frequency

Interference Statement

This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and
receiver.
3. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/television
technician for help.
Notice 1:
The changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
Notice 2:
Shielded interface cables, if any, must be used in order to
comply with the emission limits.
124