YILMAZ SKN 301 User Manual page 63

CALIBRATION OF CONVEYOR CUTTING DIMENSION
 Loosen the allen nuts on top of the conveyor support, move the support in far position, and then fix the nuts.
 Send conveyor support to any position (For example 500mm)
 Align the part to be processed with conveyor support, and cut with the tool at front.
 In case profile is longer than 500 mm (For example 2 mm longer)
 Open main screen.
 Press on
 Press on operator button in
 Enter password (1234).
 Increase the offset value about 2 mm in appeared screen
if offset is 100 mm, then edit offset value as 102 mm.
 In the case that the profile is shorter than 500 mm (For example 2 mm shorter) decrease the offset value about 2 mm in
appeared screen
as 98 mm.

Move the machine to reference position by pressing on
completed.

If machine works in inch, same calibration procedure applies.
button on the pop-up screen
on the pop-up screen
. In other words if offset is 100 mm, then edit offset value
. In other words
. Thus calibration settings are
63