Jegs 79002 Installation Instructions

Installation Instructions for 79002
2 Ton (4,000 lbs.) Hydraulic Jack with 2 Ton (4,000 lbs.) Jack Stands
CAUTION: Before using this product, read this manual and follow all
Safety Rules and Operational Instructions.
Owner and/or Operator Responsibility The
owner and/or operator shall read, study and
understand the product instructions and retain
them for future reference.
Operation
Safety information shall be emphasized and understood.
If the operator is not fluent in English, the product warnings
/cautions and instructions shall be read to and discussed with the
operator in operator's native language by purchaser/owner or his designee, insuring that the operator comprehends
their content.
Inspection
(a) Visual inspection MUST be made prior to each use of the jack. Check for cracks, cracked welds, missing or
damaged parts.
(b) Keep all moving parts clean and well lubricated.
(c) Owners and/or operators should be aware that repair of this equipment may require specialized knowledge and
facilities. It is recommended that an annual inspection of the product be made by a manufacturer or supplier's
authorized repair facility and that any defective parts, decals, or safety labels and signs be replaced with manufacturer
or supplier's specified parts.
Damaged Equipment
Any jack that appears to be damaged in any way or is found to be worn or operates abnormally SHALL BE REMOVED
FROM SERVICE IMMEDIATELY UNTIL REPAIRED. It is recommended that a manufacturer or supplier's authorized
repair facility make necessary repairs if the manufacturer or supplier permits repairs.
Alterations
Because of potential hazards associated with the misuse of equipment of this type, NO MODIFICATIONS OR
ALTERATIONS shall be made to the product.
Attachments and Adaptors
Only attachments and/or adaptors supplied by the manufacturer shall be used.
WARNING
Read, study and understand all instructions before operating this device.
• Do not exceed rated capacity. Over-loading may cause damage to/or failure of the jack.
• Always use only on hard, level surface. Do not use equipment on slopes or angles.
• Lifting device only. Jack must not be used as a jack stand to hold loads for prolonged periods of time.
• Immediately after lifting, support the vehicle with appropriate means. Use jack stands in pairs to support loads. Inspect jack stands
before use as indicated by the manufacturer's owner's manual.
• Lift only on areas of the vehicle as specified by the vehicle manufacturer's owner's manual.
• Center load on the jack saddle. Off center loads can cause loss of load or damages to load and/or equipment.
• Never work directly under a supported load.
• Do not move or dolly the vehicle while on the jack.
• Place wheel chocks under vehicle wheels on both sides to prevent rolling.
• Use in dry, well-lit areas.
• Keep children and bystanders away. Children must never be allowed in work area. Do not let children play on or around jack or
lifted load.
• Any jack that appears to be damaged in any way or is found to be worn or operates abnormally SHALL BE REMOVED FROM
SERVICE IMMEDIATELY UNTIL REPAIRED. It is recommended that a manufacturer or supplier's authorized repair facility make
necessary repairs if the manufacturer or supplier permits repairs.
• Because of potential hazards associated with this type of equipment, NO ALTERATIONS SHALL BE MADE to this product.
• Only attachments and/or adapters supplied by the manufacturer shall be used.
• Failure to heed these warnings may result in property damage, personal injury and/or death.
1-800-345-4545 jegs.com