Battery Removal And Installation - VTech PAW Patrol: The Movie: Learning Phone Parents' Manual

INSTRUCTIONS

Battery Removal and Installation

1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back
of the unit. Use a screwdriver to loosen
the screw.
3. If used batteries are present, remove
these batteries from the unit by pulling up on one end of each
battery.
4. Install 2 new 'AAA' (AM-4/LR03) batteries following the
diagram inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach
IMPORTANT: BATTERY INFORMATION
Insert batteries with the correct polarity (+ and -).
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable
•
batteries.
Only batteries of the same or equivalent type as recommended are
•
to be used.
Do not short-circuit the supply terminals.
•
Remove batteries during long periods of non-use.
•
Remove exhausted batteries from the toy.
•
• Dispose of batteries safely. Do not dispose of batteries in fire.
of
children.
4
4