Weathermatic D50 Series Installation Manual

NOZZLE INSTALLATION GUIDE
STEP 1: REMOVE DRIVE ASSEMBLY
STEP 2: INSTALL NEW NOZZLE
• Remove screws (2) on top of
nozzle cap.
• Pull off nozzle cap.
• Snap in correct nozzle.
(see Performance Chart).
• To remove nozzle, pull out
using snap ring tool or screwdriver.
STEP 3: INSTALL DRIVE ASSEMBLY
• Reinstall nozzle cap with
screws (2).
• Install new snap ring under cap.
• Place assembly in body.
• Push assembly until flush.
• Using tool push down in snap
ring slots (2) until it clicks in.
Full Circle Golf Rotor
Help Desk: 888-484-3776
support.weathermatic.com
D50 SERIES
99903375_revA