Rain Bird HN-G-01 Filter Series Quick Start Manual

Hide thumbs Also See for HN-G-01 Filter Series:

HN-G-01/ 02 Filter Series

Quick Start Guide

NOTICE:

Changes or modifications not expressly approved by Rain Bird

could void the user's authority to operate the equipment.

WARNING

It is extremely dangerous to open the filter, or control tubing

while under pressure. Always depressureize before performing

any maintenance or troubleshooting.

Rain Bird Corporation

6991 East Southpoint Rd.

Tucson, AZ

85756

D42057

QR code links to digital manual

Table of Contents

Need help?

Do you have a question about the HN-G-01 Filter Series and is the answer not in the manual?

Page 1 HN-G-01/ 02 Filter Series Quick Start Guide NOTICE: Changes or modifications not expressly approved by Rain Bird could void the user’s authority to operate the equipment. WARNING It is extremely dangerous to open the filter, or control tubing while under pressure. Always depressureize before performing any maintenance or troubleshooting.
Page 2 1. Estimate flow rate and record pressure Place a 5 gallon bucket at the water source and allow it to flow without restriction into the bucket. Time how long it takes to fill to the 5 gallon point. Example Volume of Bucket (in gallons) x 60 =43 GPM Time to fill bucket (in seconds)
Page 3 3. Installation Example How your filter is installed will depend on how your system is structured and the specific requirements of your site. This example illustrates a stand-alone filter installation with minimal added components in discharge plumbing like what is located on a municipal feed water source (or pumped water where the pump is located remotely).
Page 4 4. Mechanical Installation Piston O-ring Filter assembly 1. The Filter unit ships without the piston installed 2. Ensure that the o-ring is in place on the threads of the cylinder. Push the piston into the main body of filter. Ensure that the push to connect fitting at the top of the piston lines up with the 1/4: black tubing.

Hn-g-02 filter series