Advertisement
USB input: Use an USB cable to connect the Pasithea to your computer. Only when using a Windows operating system you should install
special drivers. In case of Linux or MAC no drivers are required. The USB input can handle sampling rates up to 384 kHz.
(For installing drivers for PC , Linux or MAC, we refer to our support website
I2S input: The I2S input is made to work in conjunction with our Hermes streamer. Use a CAT-6 UTP cable to connect both products together.
RCA outputs: Standard interlinks can be used to connect the dac to your amplifier. The "Pasithea" is designed conform the "Red book
standard" so the maximum output will be 2 Volts RMS . Your (pre)amplifier should handle this output levels.
XLR outputs: Standard XLR line cables should be used to connect the dac to your (pre) amplifier. The "Pasithea" is designed conform the "Red
book standard" so the maximum output for the XLR output will be 4 Volts RMS. Your (pre)amplifier should handle this output levels.
Mains inlet: Use a power cable to a grounded power outlet.
Remote switch: Depending the type of power amplifier it is possible to switch it "On" or "Off" by using one or both of the remote switches. For
connection a 3 pole XLR mini connector can be used and depending the way your power amplifier should be powered, it can be wired
accordingly. The following connections are available:
A)
Common
B)
Normally closed when Pasithea is switched off.
C)
Normally open when Pasithea is switched off.
https://www.sonnet-audio.com/Support.html
Connecting
)
Advertisement
