Cisco Webex 840 Manual page 11

Your Phone
Related Topics
Turn On Your Phone
Generally, your system administrator deploys your phone with multiple other phones and configures the phone
parameters before you receive the phone. In this case, the phone registers with the system and is ready for
you to use when you turn it on. If your phone doesn't work when you turn it on, contact your system
administrator.
After you power on your phone, allow the screens to cycle through a bootup screen, the Cisco splash screen,
and the Android screen. If your organization requires a PIN or passcode, the lock screen displays.
Before you begin
To maximize the storage capacity and lifespan of the battery, fully charge the battery before the first use of
the phone.
Note
To check the battery status while the phone is plugged into the charger, briefly press the Power button. When
the battery life indicator is solid, the battery charge is full.
Procedure
Press and hold the Power button until the phone vibrates and the first screen displays.
Related Topics
Unlock Your Phone
To unlock your phone screen, you likely need a password. Contact your system administrator for more
instructions. Screen lock options are None, Swipe, Pattern, PIN, or Password.
User preferences and critical alerts display only after you unlock the phone.
Note
You, or someone else, can make an emergency call from a locked phone screen using the Emergency call
button.
Phone Setup
Make an Emergency Call from a Locked Screen
Hot Swap the Battery for Webex Wireless Phone 860 and 860S
Phone Battery Charging
Hardware and Buttons, on page 13
Turn On Your Phone
Your Phone
11