Table of Contents
Advertisement
Setting a static IP address on your computer
Below are the instructions for setting Windows XP to set a static IP address for your ethernet connection:
1. Click on the Start Menu, and go to "Control Panel".
2. Click on "Network Connections".
(If you only see "Network and Internet Connections", open that first, and then click on "Network
Connections".)
3. Right click on "Local Area Connection" and select "Properties".
4. Double-click on "Internet Protocol".
5. Select "Use the following IP address ".
6. Type in the following information
IP address: 192.168.20.100
Subnet mask: 255.255.255.0
Default gateway: 192.168.20.1
7. Click "OK", and then click "OK" (or "Close").
Refer to this image for Windows Computers
Advertisement
Table of Contents
Need help?
Do you have a question about the NP124 and is the answer not in the manual?
Questions and answers