unotec KADOK II Manual page 15

line up with the notches on the holder.
Note: Handle negatives with care. Any dust, scratches or finger prints
will show up on your saved images. If possible use cotton gloves
when handling negatives. It is recommended to use compressed air to
remove any dust on the negatives.
This is not included with the film scanner but can be purchased from an
office supply or electronics retailers.
(3)Close the negative holder and press the edges so that it locks in
place. Hold it in the position as shown in the film scanner.
(4)Insert the negative holder into the slot on the right side of the film
scanner as shown.
Film Holders: The design of film holder is follow ISO standard. In some
cases, the holes on the film will not match exactly to alignment of the
holder. This is caused by a non-standard camera. In this case, there
will be a small black line on the edge of the frame that can easily be
cropped out using photo editing software.
* ISO—International Organization for Standardization
Proper operation sequence
1. Load film or negative film to board holder
2. Insert board holder to scanner
3. Connect scanner USB cable to PC
4. Press power button to turn on scanner
5. Press scanning button to start scanning
6. Operation according to indication of manual on screen
7. After finishing working, take storage card out.
8. Picture also can be read from pc through USB connection
english 15