Advertisement
Advertisement
Table of Contents
Related Manuals for LINK-MI LM-AD01
Summary of Contents for LINK-MI LM-AD01
- Page 1 HD Video Adjuster Model：LM-AD01 User Manual...
-
Page 2: Table Of Contents
Catalog .Installation Instructions …………… 2 .Projector ready to work …………… 3 .Communications settings …………… 5 .Device debugging ……………………… 7 .Image trimming ………………………… 8 .Save and load patterns ………………… 8 .Other considerations ………………… 8... -
Page 3: Installation Instructions
Installation Instructions For your safety and equipment, please be sure to read the safety instructions carefully before using this equipment. If you are in doubt, please read the manual. It has a detailed description of the device operation. If you still have any questions, please contact us and we will give you a satisfactory reply as soon as possible. -
Page 4: Projector Ready To Work
Projector ready to work 1.Overview： The most important function of the LM-AD01 device is to make the image to be projected onto the screen, and keep the image free from overflow and deformation. In accordance with the requirements of the projector in advance to do the physical location of the maximum extent to enable the display of the image to do the most clear. -
Page 5: Communications Settings
3.1.1 First through the HDMI line or VGA line connection equipment and projector, the device output for the OUTPUT area, if user buy LM-AD01 with HDBaseT function, also can be connected with the projector through the net cable. Interface as shown below:... - Page 6 3.1.2 Connect the TCP/IP interface of the device to the computer through the cable, as shown below: Net Cable 3.1.3 Press the power switch, power led is red on, can operate on the equipment. 3.2 Network settings 3.2.1 network segment setting Device to factory settings initial segment is 3 , So if you need to segment the computer control device must be set to 3 Computer setting procedure is as follows: By RJ45 Network cables connecting computers and devices TCP/IP Ports opened by computer...
-
Page 7: Device Debugging
3.2.3 local area network control Devices can be controlled via a local area network, make sure your computer and equipment can be normal under normal traffic conditions open control software, check the IP Click on the parameter configuration , the following pop-up window: Click on the synchronization, you can view the device IP Addresses. - Page 8 4.2 signal source selection Device support 1 channel VGA, 1 HDMI, 1 DVI Input signal according channel channel to access click on the appropriate signal source , The following icons: 4.3 the trapezoid adjustment Keystone correction applies to image line adjustment first coarse through the trapezoid adjustment, equal to or slightly greater than the projection screen the effective projection image display area.
-
Page 9: Image Trimming
Image trimming Coarse through the mouse, the images with minor deviations, can be adopted by to fine-tuning: Use the mouse to select the point you need to debug, select step according to the actual situation, according to computer keyboard ← ↑...
Need help?
Do you have a question about the LM-AD01 and is the answer not in the manual?
Questions and answers