Husqvarna R 214 Operator's Manual page 21

2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
Tire pressure
The correct tire pressure is 60 kPa (0.6 bar / 8.5 PSI) on
all 4 tires.
To put the cutting deck in servicing
position
WARNING:
drive belt can break and cause injury. Use
protective glasses.
1. Do step 1–9 in To remove and attach the cutting
deck on page 10 .
2. Hold the front edge of the cutting deck with two
hands and pull it out until it stops.
1590 - 007 -
The tension spring for the
3. Lift the cutting deck to vertical position until a click
sound is heard. The cutting deck is locked
automatically in the vertical position.
To put the cutting deck in mow position
1. Hold the front edge of the cutting deck with your left
hand.
2. Loosen the lock with your right hand.
3. Fold down the cutting deck and push it in until it
stops.
4. Lift the cutting height stay (A) from the stay holder
and put it in the hole.
A
5. Put the drive belt (B) in its position.
Note:
Information about the position of the drive
belt is found on the inner surface of the cutting deck
cover.
C
B
21