Bosch WVH28421GB Instruction Manual page 2

Drying table Display and Option buttons
Cottons/Coloureds (textiles made of cotton or linen such as underwe ar, T-shirts, sweaters, trousers, kitchen towels)
Display symbols
Dry weight in kg 0,5 1,0 2,0 3,0
Estimated drying time in minutes Selectable drying time in minutes
< 60 60 80 110
Cupboard dry 30 60 90 120
< 65 65 90 130
Intensive Dry Intensive Dry
Quilt/Terry towel (big or thick textiles made of cotton such as terry towels, bed sheets, table cloths, jeans, workwear)
Dry weight in kg 0,5 1,0 2,0 3,0
Estimated drying time in minutes Selectable drying time in minutes
< 60 60 90 120
Cupboard dry 30 60 90 120
< 80 80 110 140
Intensive Dry Intensive Dry
Easy-Care (textiles made of synthetic or mixed fibres such as shirts, sportswear, delicate garments)
Dry weight in kg 0,5 1,0 2,0
Estimated drying time in minutes Selectable drying time in minutes
< 50 50 100
Cupboard dry 30 60 90 120
< 60 60 110
Recommended programme Gentle Dry Gentle Dry
Display information
Consumption values
Programme Electricity Water *** Programme
consumption *** duration ***
Cottons
Cottons
Cottons Eco
Before starting a programme, the
max. load for the selected
Cottons
programme is displayed when the
Easy-Care
door is open.
The remaining time or finish-in
Mix Load
time is displayed when the door is
Delicate/Silk
closed. drying status (Auto dry
mode/Time dry duration/OFF) **
* Display shown may vary
Intensive Dry
depending on the model and
selected programme.
Gentle Dry
**Only when the drying
Fluff Clean
programme is available.
Cottons Eco
*7/3,5 kg
Option buttons
* Programme setting for testing and energy labelling in accordance with EN50229, EU directive 96/60/EC. .
You can change the spin speed and temperature even
** Programme setting for testing according to the cu rrently valid version of EN60456.
The effects depend on the progress of the programme
Note for comparative testing: to test using the tes t programmes, wash using the specified load amount and maximum spin speed.
°C Temp.
Select the Mix Load
You can change the indicated washing temperature. T
can be selected depends on the programme that has b
8
All manuals and user guides at all-guides.com
Additional functions and Individual settings
When you select a programme, the respective program me duration is displayed. You can delay
the start of the programme before it begins. The fi nish-in time indicates when the programme will
be finished. It can be set in hour increments up to a maximum of 24 h.
Press and hold the Finish in
You can change the indicated spin speed. The maximu m spin speed which can be selected
depends on the chosen programme. If
You can activate, deactivate and set the drying fun ction by touching this option button. Mode
of
Additional functions See also Programme overview
Start/Reload
For starting or pausing the washing/drying programm e.
Signal volume (for button signal and information si gnal)
kg , *:
Set to
Childproof lock Programme will not be changed by accidental operati
To activate the childproof lock:
– After the programme starts or finish in time being activated
5,67 kWh
while the selected programme is running.
.
he maximum washing temperature which
een chosen.
9
Information on the display
What to do if ...
Please close the door immediately because o water level. Water is leaking out.
In pause status
Door is locked for safety reasons (water level or temperature are too high). No water supply.
For washing programme : In pause status, Detergent not dispensed.
Washer dryer door cannot
be
Door cannot be locked/unlocked due to high t ure of the door lock. Keep the
Programme does not start.
machine switched on for about 1 minute. Then chine can be locked/unlocked again.
Door cannot be opened due to the high tempe fter the drying programme.
Detergent solution is not
The cooling down process will continue until th splay disappears and the door can be
drained.
opened.
Flashing (no water supply):
Water not visible in the drum.
Tap turned on?
Inlet filter blocked? Clean filter .
Spin result not satisfactory.
Clean drain pump . Spin cycle performed several
times.
Hold down the
Compartment
Odour formation in the
Switch off the appliance, wait 5 seconds and it back on.
other displays washer dryer.
If the display appears again, call the custome vice.
Foam escapes from the
detergent drawer.
Safety instructions
– Read and follow the operating and Installatio maintenance instructions and all other
Excessive noise, vibrations
information enclosed with the washer dryer.
Option and "wandering" during spin
– Retain documents for subsequent use.
cycle.
Risk of electric – Never pull out the mains plug by tugging t cord.
shock – Never insert/pull out the mains plug with d ds.
Risk of death For worn-out appliances:
– Pull out the mains plug.
Display panel/indicator
– Sever the power cord and discard togethe plug.
lamps do not function while
– Destroy the lock on the washer dryer door. ll prevent children from
the appliance is running.
locking themselves in and risking their lives.
Risk of suffocation – Keep packaging, plastic film and packagin ut of the reach
Programme sequence
of
longer than usual.
Risk of poisioning – Keep detergents and care products out of of children.
Risk of explosion – Items of laundry pretreated with cleaning a ontaining solvents, e.g.
stain remover/cleaning solvents may lead to osion after being
on. Detergent residues on the
loaded into the washer dryer.
laundry.
Rinse items of laundry thoroughly by hand b
Risk of injury – Washer dryer door may become very hot.
– Take care when draining hot detergent so
Spinning noise during drying.
– Do not climb onto the washer dryer.
– Do not lean on the open washer dryer doo
57 l
Differently coloured fluff from
– Do not touch the drum in case it is still spi .
the previous drying cycle is
– Ensure that the pump cap is screwed on w achine is running to
redeposited to the laundry in
prevent the escape of water and contact wit pump parts.
the following washing cycle.
– If a drying programme was interrupted, the dryer and the laundry
may be very hot, select Intensive Dry Water inlet noise during
drying, Water tap symbol
is
10
11
What to do if ...
– Fit/refit drainage hose correc Drying duration extend – According to the
temperature will res
– Tighten the screw connection and
drying duration will
– Start /Reload
to remove exhaust
– Air inlet filter bloc
Drying programme doe start. – Drying programm
– Start /Reload
– Clean the drain pump. The drying result is not – Too high environm
satisfactory (laundry is
dry enough).
– Not a fault – water below the
– Wash small and large items o
–
– Not a fault – unbalanced load usts the
imbalance.
– Run the Fluff Clean
– Too much detergent used?
Mix 1 tablespoon of fabric softe water and
pour into compartment II in the
– Reduce detergent dosage for
– Use commercially available lo care
products which are suitable for .
A small amount of wate – Drying time is sho
– Are the appliance feet fixed?
moisture may rema
observed dripping on t
Secure the appliance feet. Load
dried laundry load whe quickly creates a su
door is opened. drying system.
– Open the door slo
If you cannot correct a is required:
– Turn the programme and pull the mains Off
– Power failure?
– Turn off the tap and
– Circuit breaker tripped? Rese /change the
fuse.
– If the fault occurs repeatedly, service.
– Not a fault – unbalanced load usts
imbalance by repeatedly distrib
Emergency release e.g. in the event o
– Not a fault – foam detection sy an additional
rinse cycle.
The programme will
– Occasionally, phosphate-free ter- However, if the laun
insoluble residues. machine door can be
– Select Rinse/ Spin
Risk of scalding.
The detergent solut
– This is an innovative process g to reduce
If possible, leave it
energy consumption during dry
Do not open the wa
6:58 h
– Run the Fluff Clean through the glass.
– Set the programm
12
ironment
so the
are displayed
tilation
esidual
he door
re from the
s restored.
ing
Washing machine WVH28421GB
een
en Instruction manual
13