VONROC V18-1 Original Instructions Manual page 7

• Be care of the danger of the kickback force on
the spray assembly when opening the trigger
gun and grasp the gun with hands firmly.
• To reduce the risk of injury, close supervision
is necessary when a machine is used near
children. High-pressure cleaner shall not be
used by children or untrained person.
• Know how to stop the machine and bleed
pressures quickly. Be thoroughly familiar with
the controls.
• Stay alert and watch what you are doing.
• Do not operate the machine when fatigued or
under the influence of alcohol or drugs.
• Keep operating area clear of all persons.
• Do not overreach or stand on unstable support.
Keep good footing and balance at all times.
• Follow the maintenance instructions specified
in the manual.
• This machine must be grounded. If it has
malfunction or breakdown, grounding provides
a path of least resistance for electric current to
reduce the risk of electric shock. The plug must
be plugged into an appropriate outlet that is
properly installed and grounded in accordance
with all local codes and ordinances. The rating
voltage (V/Hz) of the machine has to be in
compliance with the local power supplying
voltage.
• Check with a qualified electrician or service
personnel if you are in doubt as to whether the
outlet is properly grounded. Do not modify the
plug provided with the machine. If it will not
fit the outlet, have a proper outlet installed by
a qualified electrician. Do not use any type of
adapter with this machine.
• Use only extension cords that are intended
for outdoor use and the socket must be of
watertight construction. These extension cords
are identified by a marking "Acceptable for use
with outdoor machines; store indoors while
not in use." Use only extension cords having
an electrical rating not less than the rating of
the machine. Do not use damaged extension
cords. Examine extension cord before using and
replace if damaged. Inadequate extension cords
can be dangerous. Do not abuse extension cord
and do not yank on any cord to disconnect.
Keep cord away from heat and sharp edges.
Always disconnect the extension cord from the
receptacle before disconnecting the machine
from the extension cord.
WWW.VONROC.COM
• To reduce the risk of electrocution, don't start
and run the machine in the rain or storm. Keep
all connections dry and off the ground. Do
not touch plug with wet hands. It is strictly
prohibited to let water leak into the machine.
• When the machine is running, please maintain
a constant water supply. Without water
circulation will damage the sealing rings of the
machine.
• It is necessary to turn on the spray lance within
one or two minutes after the machine has been
started. Otherwise, the temperature of the
circulating water within the machine will soon
rise to a critical point, which will cause damage
to the sealing rings inside the machine.
• Don't start and run the machine in a place
excessively cold so as to prevent the machine
from the freezing current.
• This machine has been designed for only using
cleaning water, do not use corrosive chemicals.
• Use cleaning agent supplied or recommend by
the manufacturer.
• High-pressure jets can be dangerous if subject
to misuse. The jet must not be directed at
persons, animals, live electrical equipment or
the machine itself. Pressure washers should not
be pointed at tire walls, as it may be possible to
damage them.
• Do not direct the jet against yourself or others
in order to clean clothes or footwear.
• Disconnect from the electrical power supply
before carrying out user maintenance.
• If the mains cable is damaged it must be
replaced by the manufacturer, or its service
agent or similarly qualified person to avoid a
hazard.
• Do not use the machine if a supply cord or
important parts are damaged, e.g. safety
devices, high pressure hoses, trigger gun.
• Be aware of the recoil caused by the water jet
when the machine is switched on.
• When the machine is moving and installing,
the machine must be in flat. When moving the
machine, pulling the handle to move it.
• Connect to the water supply. The machines
are not suitable for connection to portable
water mains. Connect the machine to the water
supply. (It can be a water container).
• Do not use the pipe if the pipe is damaged.
If you want connect this machine to portable
water mains, you must install a backflow
EN
7