VONROC V18-1 Original Instructions Manual page 6

EN
operation.
• The cross-section of any extension cables
used must be proportional to their length, i.e.
the longer the extension cable, the greater the
cross-section; cables with a protection level of
"IPX5" must be used.
• Position the cleaner AS NEAR POSSIBLE to the
water supply.
• The packaging is easily recyclable, and must be
disposed of in compliance with the regulations
in force in the country of installation.
• Use the cleaner only with accessories
and replacement parts authorized by the
manufacturer. The use of original accessories
and replacement parts will ensure safe,
troublefree operation.
• The cleaner must be used standing on a secure,
stable surface.
• Avoid unintentional firing of the trigger. Do not
carry the lance/ trigger assembly with your
hand over the trigger. Always use the trigger
lock mechanism.
• Ensure that the safety lock on the trigger
is used, when you have stopped using the
pressure washer to prevent accidental
operation.
• Read all the instructions before using the
machine.
• Machines shall not be used by children.
Children should be supervised to ensure that
they do not play with the machine. This machine
is not intended for use by persons (including
children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge.
• The electrical supply connection shall be made
by a qualified person and comply with IEC
60364-1. The electric supply to this machine
should include a residual current device that
will interrupt the supply if the leakage current to
earth exceeds 30 mA.
• The machine is intended to be used at a
temperature above 0 degree. (Only for machine
with power cord of H05VV-F).
• The operating method to be followed in the
event of accident (e.g. contact with detergents:
rinse with an abundance of clean water) or
breakdown to prevent unsafe situations.
• This machine has been designed for use with
the cleaning agent supplied or recommended
by the manufacturer. The use of other cleaning
6
agents or chemicals may adversely affect the
safety of the machine.
• Recommend the operator to wear ear
protectors.
• Do not use the machine within range of persons
unless they wear protective clothing.
• Do not direct the jet against yourself or others
in order to clean clothes or foot-wear.
• Risk of explosion-Do not spray flammable
liquids.
• High pressure hoses, fittings and couplings
are important for the safety of the machine.
Use only hosed, fittings and couplings
recommended by the manufacturer.
• To ensure machine safety, use only original
spare parts from the manufacturer or approved
by the manufacturer.
• Water that has flown through backflow
preventers is considered to the non-potable.
• The machine shall be disconnected from its
power source by removing the plug from the
socket-outlet during cleaning or maintenance
and when replacing the machine to another
function.
• Observe a distance of at least 30cm when
using the jet to clean painted surfaces to avoid
damaging paintwork.
• Do not use the machine if a supply cord or
important parts of the machine are damaged,
e.g. safety devices, high pressure hoses, trigger
gun.
• If an extension cord is used, the plug and
socket must be of watertight construction.
• Inadequate extension cords can be dangerous.
If an extension cord is used, it shall be suitable
for outdoor use, and the connection has to be
kept dry and off the ground. It is recommended
that this is accomplished by means of a cord
reel which keeps the socket at least 60mm
above the ground.
• In order to avoid a hazard due to inadvertent
resetting of the thermal cut-out, this appliance
must not be supplied through an external
switching device, such as a timer, or connected
to a circuit that is regularly switched on and off
by the utility.
• To ensure the machine safety, please only use
original spare parts (including nozzle) from the
manufacturer or approved by the manufacturer.
Do not use the machine before you changed
them if they are damaged.
WWW.VONROC.COM