Tektronix 2715 User Manual page 306

Appendix C: System Messages
C–4
DELETE EXISTING PROGRAM FIRST
A user-defined program already exists in this register. It must be deleted
before the new one can be stored.
DELETE EXISTING TABLE FIRST
An attempt was made to store an antenna correction factor table in a file
position that is already used. You must delete the file with the table deletion
menu prior to attempting to store the new file.
DESTINATION WAVEFORM CONFLICT
An attempt was made to enable two functions that use the same destination
waveform. The display line, ensemble average, min hold, dBmV/M and
waterfall mode use destination waveforms.
DIRECTORY ERROR IN FILE
Firmware/hardware error. Contact your local Tektronix service center or
representative if message persists.
DISCONNECT INPUT SIGNAL
Input signal needs to be removed in following step.
DISPLAY LINE OFF SCREEN
The display line is out of range either at the top or bottom of the CRT
display.
EDITING BUFFER IS EMPTY
The local editing buffer for either the UDP or antenna tables is empty. If you
are attempting to delete the editing buffer, the error message is simply to
inform the you that the selected action is invalid.
END OF FILE
Firmware/hardware error. Contact your local Tektronix service center or
representative if message persists.
ENSEMBLE AVERAGE COMPLETE
Signifies completion of an ensemble average process.
ERROR
Firmware error. Contact your local Tektronix service center or representative
if message persists.
FATAL ERROR IN FILE
Firmware/hardware error. Contact your local Tektronix service center or
representative if message persists.
FILE NOT FOUND
Occurs when attempting to access a file that does not exist.
2715 User Manual