Bar Code Confi Guration - JUKI AP-876 Instruction Manual

6. Bar code confi guration
By reading the bar code sheet attached at the end of this manual, the sewing pattern can be switched
to the one corresponding to the selected bar code. Separate the attached bar code sheet for your use.
This bar code sheet is compatible to Code39.
When creating bar codes to a standard other than Code39, create the codes according to the following
format.
• 4 byte ASCII code
• "Pattern type", "hundreds place", "tens place", "ones place"
Pattern type
Pattern type
U or 0 : Corresponds to the user patterns
D or 1 : Corresponds to the sewing data registered in the pattern button
Pattern No.
User pattern : No. 001 to No. 999
Sewing data registered in the pattern button : No. 001 to No. 050
Both the pattern type and the numbers shall be written in ASCII code.
In the case of D001 as shown above, it will be described as 0x44 0x30 0x30 0x31.
Start/stop character etc. shall be created according to the bar code standard used.
If the margin at both sides of the bar code is small, there is a possibility of reading error.
Therefore, try to have as much margin as possible on both sides. If the bar codes at the end of this
manual are used, make a copy of the sheet, and then cut along the dotted lines.
Example
D 0 0 1
Pattern No.
– 5 –