AOK -120WiP Installation Instruction

The courtyard lamp

Advertisement

The Courtyard Lamp Installation Instruction
Please read the installation manual carefully before installation and keep the manual for future use.

Warning

1.Electrician must have related certificates , knowledge and working experience. The work must be assigned to
each electrician based on their position and responsibility.
2.The lens of the lamp is PC + glass, which must be handled carefully during installation, otherwise will be
easily scratched and damaged. When the face of the lamp is putting on the ground, it must be protected
with soft cloth or other protective materials.
3.Installation must be proceeded when the electricity is shut off , no action taken if electricity connected.
4.Construction must be proceeded according to related regulations , including the tools and equipments used.
For example: working voltage range , Warning sign , flashing lamp , helmet , and working clothes etc.
5.Make sure the weather is suitable for high power electricity work when proceed construction.

Statement

1.The crane used to install the courtyard lamp must come with lifting platform, warning signs and flash lamp etc.
2.Electric power must be cut off before installation or maintanence of Parking Lot Light.
3.Maintenance must be performed by professional staff.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AOK-120WiP and is the answer not in the manual?

Questions and answers

Summary of Contents for AOK AOK-120WiP

  • Page 1 The Courtyard Lamp Installation Instruction Please read the installation manual carefully before installation and keep the manual for future use. Warning 1.Electrician must have related certificates , knowledge and working experience. The work must be assigned to each electrician based on their position and responsibility. 2.The lens of the lamp is PC + glass, which must be handled carefully during installation, otherwise will be easily scratched and damaged.
  • Page 2 Product parts include introduction The Courtyard Lamp Water-proof Gasket (1) Grub screw(5) Arm(1) Set screws(3) Elastic gasket(3) Preparation for installation of the courtyard lamp Step 1: Place the waterproof gasket in the groove position of the lamp arm. Step 2: Put the wire through the arm. Water-proof Gasket Groove Wire...
  • Page 3 Step 5 : Wiring, connect the L,N,GND wires on the lamp to the corresponding L,N,GND cables on the conduit. Step 6 : Insert the elbow of the lamp into the lamp post and tighten 4 fixing screws with an inner hexagon wrench. The torsion:19-22 N.m lamp-post Ø60mm...

This manual is also suitable for:

Aok-75wip94054090

Table of Contents