Care And Maintenance; Troubleshooting; Warranty - Project Source 40017 Manual

CARE AND MAINTENANCE

It is recommended the fixtures be wiped down weekly using a soft, dry, or damp cloth.
DO NOT use any abrasives such as car wax, polishes, glass cleaners or chemicals, as this will
scratch/remove/damage the protective coating, allowing moisture and pollutants to come in contact
with the finish, which will result in discoloration and pitting.
FAILURE TO FOLLOW THE ABOVE CARE INSTRUCTIONS WILL VOID THE WARRANTY OF
THE FIXTURE.

TROUBLESHOOTING

PROBLEM
Bulb won't light.
Fuse blows or circuit breaker
trips when light is turned on.

WARRANTY

The manufacturer warrants all of its lighting fixtures against defects in materials and workmanship
for one (1) year from date of purchase. If within this period the product is found to be defective in
material of workmanship the product must be returned, with a copy of the bill of sale as proof of
purchase in the original carton to the place of purchase. The manufacturer will, at its option, repair,
replace , or refund the purchase price to the customer. All cost of installation and removal of the
fixture is the responsibility of the customer. This warranty does not cover fixtures becoming defective
due to misuse, accidental damage, improper handling and/ or installation and specifically excluded
liability for direct, incidental or consequential damages. As some states do not allow exclusions of
limitations on an implied warranty, the above exclusion and limitation may not apply. This warranty
gives you specific rights and you may also have other rights which may vary from state to state.
POSSIBLE CAUSE
1. Bulb is burnt out.
2. Power is off.
3. Bad wire connection.
4. Bad switch.
Crossed wires or power
wire is grounding out.
8
CORRECTIVE ACTION
1. Replace light bulb.
2. Check if power supply is on.
3. Check wiring.
4. Test or replace switch.
Check wiring connections.