Table of Contents
Advertisement
2-2: WHITE BALANCE
1.
Place the set in Aging Test for more than 15 minutes.
2.
Receive the white 100% signal from the Pattern
Generator.
3.
Press the INPUT SELECT button on the remote control
to set to the AV mode.
4.
Using the remote control, set the brightness and contrast
to normal position.
5.
Activate the adjustment mode display of Fig. 2-1 and
press the channel button (03) on the remote control to
select "R DRIVE (N)".
6.
Press the CH. UP/DOWN button on the remote control to
select the "R CUTOFF (N)", "B.DRIVE(N)", "B CUTOFF
(N)", "R DRIVE (C)", "R CUTOFF (C)", "B.DRIVE(C)",
"B CUTOFF (C)", "R DRIVE (W)", "R CUTOFF (W)",
"B.DRIVE(W)"or "B CUTOFF (W)".
7.
Adjust the VOL. UP/DOWN button on the remote control to
whiten the R CUTOFF (N), B.DRIVE(N), B CUTOFF (N),
R DRIVE (C), R CUTOFF (C), B.DRIVE(C), B CUTOFF
(C), R DRIVE (W), R CUTOFF (W), B.DRIVE(W) and B
CUTOFF (W) at each step tone sections equally.
8.
Perform the above adjustments 6 and 7 until the white
color is achieved.
ELECTRICAL ADJUSTMENTS
D-2
Advertisement
Table of Contents
