Table of Contents
Advertisement
4.
SELECTING THE ADJUSTING ITEMS
1) Every pressing of CHANNEL ▲ button in the service mode changes the adjustment items in the order of table-1.
(▼ button for reverse order)
5.
ADJUSTING THE DATA
1) Pressing of VOLUME
range depends on the adjusting item.
6.
EXIT FROM SERVICE MODE
1) Pressing POWER button to turn off the TV once.
INITIALIZATION OF MEMORY DATA (QA02)
n
After replacing QA0, the following initialization is required.
1. Enter the service mode, then select any register item.
. Press and hold the CALL button on the Remote, then press the CHANNEL ▲ button on the TV. The initialization of
QA0 has been complated.
3. Check the picture carefully. If necessary, adjust any adjustment item above.
Perform "Auto tune" on the owner's manual.
CAUTION: Never attempt to initialize the data unless QA0 has been replaced.
7.
TEST SIGNAL SELECTION
1) Every pressing of
below in SERVICE MODE.
Signal off
R
All White
+/– button will change the value of data in the range from 00H to FFH. The variable
button on the Remote Control changes the built-in test patterns on screen as described
G
B
All Black
Signals
• Red raster
• Green raster
• Blue raster
• All Black
• All White
- 8 -
Picture
3WL66A/E/R/T
Advertisement
Table of Contents
