Table of Contents
Advertisement
ITEM
WHITE BALANCE
ADJUSTMENT
•
CUTOFF ADJUSTMENT
(RCUT)
(GCUT)
(BCUT)
•
DRIVE ADJUSTMENT
(GDRV)
(BDRV)
1. Set Contrast to 40, and brightness to +20 by picture control.
2. Set the TV in service mode, and get the inside W/B adjusting signal with VIDEO
button.
3. Select RCUT, GCUT and BCUT with CHANNEL
values to 32, and to set GDRV and BDRV to 20 with VOLUME
4. Press -/- - button on the remote control and rotate Screen VR to get one slight
horizontal line on screen.
Note: Every pressing of -/- - button provides Horizontal line picture and Normal
picture alternately.
5. Press -/- - button to release horizontal line picture, and select the two other colors
which did not light in the above step with CHANNEL
UME
– /+ buttons so that three colors slightly light in the same level.
To correct white balance in light area,
select GDRV and BDRV with CHANNEL
,
buttons to adjust.
To correct white balance in dark area,
perform fine adjustment of RCUT, GCUT
and BCUT.
- 11 -
ADJUSTMENT PROCEDURE
,
buttons, to set individual
– /+ buttons.
,
buttons. Then tap VOL-
Light area check
(to show white)
Dark area check
Advertisement
Table of Contents
