Table of Contents
Advertisement
1. ENTERING TO DESIGN MODE
1) When in Service mode (see
page 6), press CALL button
on the remote control once.
S
When QA10 is initialized, items "OPT" ,"OPT1" and "OPT2" of DESIGN MODE are set to the data of the representative model
of this chassis family.
Therefore, because ON-SCREEN specification remains in the state of the representative of model. This model is required to
reset the data of items "OPT" ,"OPT1" and "OPT2" according to current on-serviced model .
2. SELECTING THE ADJUSTING ITEMS
Every pressing of CH t button in the design mode changes the adjustment items in the order of table-3.
(s button for reverse order)
Refer to table-3 for data of design mode.
(See SETTING & ADJUSTING DATA on page 12)
3. ADJUSTING THE DATA
Pressing of ; -/+ buttons will change the value of data.
DESIGN MODE
2) While pressing CALL button
again and press MENU button
on the TV.
D
(Design mode)
– 9 –
3) Press MENU button on TV.
ITEM
Press
DATA
Press
(Adjustment mode)
Advertisement
Table of Contents
