Using The Sony Dpp-Ms300/Ms300E Printer Driver - Sony DPP-MS300E User Manual

Using the Sony DPP-MS300/MS300E
Printer Driver
Note
This sections explains the
settings and operations
with a typical application
as an example.
Depending on the
application, print settings
and operations may
differ. For the details,
refer to the manual of
your application.
Tip
When you print in 306 dpi
using the application
software, set the picture
size to 1376 x 1024 pixels.
Notes
• Use the set of print
paper and print
cartridge supplied
together in the same
carton. If you use the
paper and cartridge in
a different
combination, proper
printing results may
not be obtained or
other trouble may
occur. Also make sure
to set "Size" as shown
in the table. If you
make a different
setting, you cannot
print.
• For the details on print
paper and print
cartridge, refer to
"Using print packs (not
supplied)" on page 14
of the operating
instructions of the
printer.
With the Sony DPP-MS300/MS300E Printer Driver,
you can print an image from your PC hard disk using
the "Sony Digital Photo Printer Utility for MS300/
MS300E" or other application software.
1
Start the application software that you use to print
with, and select the image to be printed.
2
Click "Print Setup" from the "File" menu of the
application.
The "Print Setup" dialog box appears.
3
Set the printer.
The above dialog box is an example of "Sony Digital
Photo Printer Utility for MS300/MS300E." The dialog box
differs depending on the application.
1 Set "Printer" to "Sony DPP-MS300."
2 Set "Size" by referring to the combination
below.
Print paper Print
loaded cartridge loaded
Standard paper Standard type
2/16-cut sticker Standard type
Super Coat Super Coat type A6 Super Coat
3 Set "Orientation."
To print in portrait (tall) format, select
"Portrait." To print in landscape (wide) format,
select "Landscape."
Select "Sony
DPP-MS300"
as the printer.
Select the
paper.
Select the
orientation of
the paper.
"Size" setting
A6 Standard/Sticker
A6 Standard/Sticker
continued
Basic Operations
19 GB