Advertisement
Quick Links
TFB-180SA / TFB-180BSA
Detector base integrated with a
addressable horn/strobe horn
Technical instructions
TFB-180BSAHb101.pdf
Date 4.2.2020
1.0
1
Rev
T
G
F
D
ELEFIRE
AS AND
IRE
ETECTORS
L
.
TD
P.O. Box 7036
Petach Tikwa 49250
Tel:
(03) 970 0400
Fax:
(03) 921 1816
Email: info@telefire.com
www.telefire.com
Advertisement
Related Manuals for Telefire TFB-180SA
Summary of Contents for Telefire TFB-180SA
- Page 1 TFB-180SA / TFB-180BSA Detector base integrated with a addressable horn/strobe horn Technical instructions ELEFIRE AS AND ETECTORS P.O. Box 7036 Petach Tikwa 49250 Tel: (03) 970 0400 TFB-180BSAHb101.pdf Fax: (03) 921 1816 Date 4.2.2020 Email: info@telefire.com www.telefire.com...
- Page 2 Note The equipment must not be installed, operated or maintained before reading this manual and understanding its content. 2019 – 2020 LL RIGHTS RESERVED TO ELEFIRE AS AND IRE DETECTORS...
-
Page 3: Installation
AS AND IRE DETECTORS 1 Introduction TFB-180SA and TFB-180BSA are devices with a base for an addressable detector integrated with an addressable horn or a base for an addressable detector integrated with an addressable strobe horn. There are two models: •... - Page 4 2019 – 2020 © A Rev 1.01 Date 4.2.2020 LL RIGHTS RESERVED TO ELEFIRE AS AND IRE DETECTORS Maximum cable length (for a given size) as input Cable type Cable Diameter Section ADR-7000 ,SAVER-7000 ,GUARD-7 , ו - ADR-3000 (AWG) (mm) 0.912 0.653...
- Page 5 The addition or removal of assemblies from the panel will be done when the power sources to the panel (AC input voltage and batteries) are disconnected. To the next device From the panel or previous device Drawing 1: wiring of TFB-180BSA or TFB-180SA Page 3 of 7...
- Page 6 2019 – 2020 © A Rev 1.01 Date 4.2.2020 LL RIGHTS RESERVED TO ELEFIRE AS AND IRE DETECTORS Installation 3.2.1 Programming of the device address Burn the address of the horn/strobe horn to the device's card. Use the wire supplied with the software PROG-4000 or the technician kit TFC-7000 and connect the gator clips to lug 1 (positive) and 2 (negative).
- Page 7 2019 – 2020 © A Rev 1.01 Date 4.2.2020 LL RIGHTS RESERVED TO ELEFIRE AS AND IRE DETECTORS 3.2.4 Configuration switches – TFB-180BSA Note The switch is off when the selector is close to the digit, and on when the switch is far away from the digit.
-
Page 8: Preinstallation Tests
2019 – 2020 © A Rev 1.01 Date 4.2.2020 LL RIGHTS RESERVED TO ELEFIRE AS AND IRE DETECTORS Switch 1: sets the operating mode to horn/strobe or horn only. Switch 2: volume adjustment: high volume (off) or low volume (On). Switches 3 and 4: the horn sound: o Continuous sound (910Gz): switch 3 is On, switch 4 is On o Bell (1440 Hz), switch 3 is On;... -
Page 9: Technical Data
Operating voltage (supplied by the operation panel on the device communication line) 20V modulated (supplied by the operation panel or addressable output assembly) 24 Vdc TFB-180SA Maximum current consumption – device line ..180 µA (quiescent state) 2 mA (alarm state)
Need help?
Do you have a question about the TFB-180SA and is the answer not in the manual?
Questions and answers