Sony Handycam DCR-HC16E Operation Manual page 13

To remove the battery pack
BATT (battery)
release button
Battery pack
1
Set the POWER switch to OFF (CHG).
2
Slide the battery pack out in the direction
of the arrow while pressing the BATT
(battery) release button down.
b Note
• If you do not use the battery pack for a long time, use
up the battery pack completely before storing it. See
page 83 about storage of the battery pack.
To check the remaining battery – Battery
Info
DSPL/BATT INFO
You can check the battery's current charge level
and its current remaining recording time both
during charging or when the power is turned off.
1
Set the POWER switch to OFF (CHG).
2
Open the LCD panel.
3
Press DSPL/BATT INFO.
The battery information appears for about 7
seconds.
POWER
switch
POWER switch
Keep the button pressed to view it for about
20 seconds.
BATTERY INFO
BATTERY CHARGE LEVEL
0% 50%
REC TIME AVAILABLE
LCD SCREEN
VIEWFINDER
A Battery charge level: Displays
approximate remaining amount of
power left in the battery pack.
B Approximate possible recording time
using the LCD panel.
C Approximate possible recording time
using the viewfinder.
Charging time
Approximate number of minutes required when
you fully charge a fully discharged battery pack
at 25°C (77°F). (10 – 30°C (50 – 86°F)
recommended.)
Battery pack
NP-FP50 (supplied)
NP-FP70
NP-FP90
Recording time when recording with the
LCD screen on
Approximate number of minutes available
when you use a fully charged battery pack at
25°C (77°F).
When LCD BACKLIGHT is set to ON
Battery pack Continuous
recording
time
NP-FP50 110
(supplied)
NP-FP70 235
NP-FP90 415
100%
: 88 min
: 100 min
125
155
220
Typical*
recording
time
60
125
225
,continued
13
Getting started