IKEA RENODLAD Manual page 15

ENGLISH
When the rinse aid chamber is empty, the
rinse aid indicator turns on. If the drying
results are satisfactory while using multi-
tablets only, you can deactivate the
notification for refilling the rinse aid.
However, for best drying performance,
always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
End sound
You can activate an acoustic signal that
sounds when the programme is completed.
Acoustic signals sound also when
a malfunction of the appliance
occurs. It is not possible to
deactivate these signals.
AutoOpen
AutoOpen improves the drying results with
less energy consumption. The appliance
door opens automatically during the drying
phase and remains ajar.
AutoOpen is automatically activated with all
programmes other than Rinse & Hold.
Caution! Do not try to close the
appliance door within 2 minutes
after automatic opening. This can
cause damage to the appliance.
Caution! If children, pets or
people with disabilities have
access to the appliance,
deactivate AutoOpen. The
automatic opening of the door
may pose a danger and expose
possible hazards inside the
appliance (such as knives, sharp
objects, chemicals).
When AutoOpen opens the door,
Beam-on-Floor might not be
completely visible. To see if the
programme is complete, look at
the control panel.
Key tones
The buttons on the control panel make a
click sound when you press them. You can
deactivate this sound.
Latest programme selection
You can set the automatic selection of the
most recently used programme and options.
The latest programme that was completed
before the appliance deactivation is saved. It
is then selected automatically after you
activate the appliance.
When the latest programme selection is
disabled, the default programme is ECO.
Setting mode
How to enter setting mode
You can enter setting mode before starting a
programme. You cannot enter setting mode
while the programme is running.
To enter setting mode, press and hold
simultaneously
seconds.
• The lights related to
are on.
• The display shows the current value
of the first available setting.
and for about 3
, and
15