Black & Decker CLMA4825L2 Manual page 14

ENGLISH (Original instructions)
the mowers kick into high power while in lighter grass, the
mowers lower the power output to conserve battery life and
extend runtime
Storage
Warning! Rotating blade can cause serious injury. Release
bail handle (2) to turn mower off, remove safety key, and re-
move battery before lifting, transporting, or storing the mower.
Store in a dry place.
Warning! To avoid being pinched, keep fingers away from
area between handles when folding down handles.
Warning! Make sure cord does not become stretched or
pinched in the joints of the handles during folding. This can
cause damage to the cord.
The handle of the mower can be easily folded down for quick
and convenient storage.
Holding onto the handle, open, but do not remove, the
u
lower-handle attachment levers (6) and fold the handle to
the front of the mower as shown in figure S.
Open, but do not remove, the upper-handle attachment
u
levers (5) and fold the upper handle (3) back over the
lower handle (4) as shown in figure T.
The mower shold be compacted down as shown in
u
figure U.
Carrying the mower
The mower can be carried using the convenient carry
u
handles (12) as shown in figure V. DO NOT attempt to
lift the mower by grasping the upper handle (3) or lower
handle (4).
Mowing tips
Warning! Always inspect area where mower is to be used
and remove all stones, sticks, wire, bones, and other debris
which might be thrown by the rotating blade.
Warning! Mow across the face of slopes, never up-and-down.
Exercise extreme caution when changing direction on slopes.
Do not mow excessively steep slopes. Always maintain good
footing.
Release bail handle to turn mower "Off" when crossing
u
any gravel area (stones can be thrown by the blade).
Set mower at highest cutting height when mowing in rough
u
ground or in tall weeds. Removing too much grass at one
time can cause the motor to be overloaded and to stop.
Refer to troubleshooting guide.
If a grass collection bag (8) is used during the fast growing
u
season, the grass may tend to clog up at the discharge
opening. Release bail handle to turn mower off and
remove the safety key. Remove the catcher and shake
the grass down to the back end of the bag. Also clean
out any grass or debris which may be packed around the
discharge opening. Replace the grass catcher.
14
If mower should start to vibrate abnormally, release bail
u
handle to turn mower off and remove safety key. Check
immediately for cause. Vibration is a warning of trouble.
Do not operate mower until a service check has been
made. Refer to troubleshooting guide in manual.
Always release bail handle to turn mower off and remove
u
safety key when leaving it unattended even for a short
period of time.
Tips for optimum use:
Slow down in areas where the grass is especially long or
u
thick.
Avoid mowing when the grass is wet from rain or dew-
u
soaked.
Cut your lawn frequently, especially during high growth
u
periods.
Note: It is recommended that your mower be recharged after
use to prolong the battery life. Frequent charging will not
harm your battery, and will ensure that the battery is fully
charged and ready for its next use. Storing battery not fully
charged will shorten battery life.
Removing and installing blade
Warning! When reassembling the blade system, ensure each
part is reinstalled correctly, as described below.
Improper assembly of the blade or other parts of the blade
system may cause serious injury.
Warning! Release bail handle to turn mower off, wait for the
blade to stop, and remove safety key and battery pack.
Cut a piece of 2x4 wood (31) (about 2 feet long) (610 mm)
u
to keep blade from turning while removing bolt (32).
Wear gloves and proper eye protection.
u
Turn the mower on its side. Be careful of sharp edges of
u
blade. Position wood and unscrew bolt with 1/2" wrench
(33) as shown in figure W.
Remove bolt and washer (34). pull off blade (35) as shown
u
in figure X. The fan (36) should not be removed. Examine
all pieces for damage and replace if necessary.
The blade can only be attached to the fan in one direction.
u
To reassemble, line up the d-shaped hole of the blade with
the d-shaped post of the fan, ensuring the writing on the
blade faces out away from the mower.
To tighten firmly, position the piece of wood as shown
u
in figure Y to keep the blade from turning. Slide the bolt
through the washer and screw bolt into place. Tighten with
the wrench.
Blade sharpening
Keep blade sharp for best mower performance. A dull blade
does not cut grass cleanly. Use proper eye protection while
removing, sharpening, and installing blade. Ensure that safety
key and battery pack is removed.