Daken Saturn Evo Mounting Instructions page 7

HOW IT WORKS
The lock is composed of an external shell turning on two fixed
half-flanges.
Securing is at complete discretion of the user (see "How to use").
CAUTION
•Before installing the device check that the doors are perfectly
aligned ;
1
• Prefer smooth surfaces to areas where the van body is
irregular;
• If necessary, use the plastic shims to level and/or align the
surfaces 2 ;
WHERE YOU CAN INSTALL IT The device can be installed both on
the rear and on the side door of the van.
do not install the device on the forepart of
CAUTION
3
the side door .
Use the adhesive drill template to mark the holes needed to
4
install the device, using the central axis.
Before drilling, check that the template is in the right position.
5
• Make 6 ø4.5 holes for mounting with long screws OR 6 ø6
holes for mounting with rivets on thin sheets (max 2.5 mm).
• Make 1 ø3.5 hole (two holes are marked on the adhesive
drill template) only on the shutter/sliding door.
DISCRETIONARY In case of thin sheets (max 2.5 mm) once
6
you have drilled the 6 ø6 holes (step 5), insert the rivets with a
rivet plier (not included).
After drilling, clean the door surface and remove any burr.
7
Better treat the door surface with rust preventive paint.
CAUTION Check that the surface of the holes does not have burrs.
8
Saturn Evo | Mounting instructions
Place the rubber protections in correspondence of the holes and fix the
two half-flanges in this way:
REAR DOORS
the two half-flanges are symmetrical and interchangeable
SLIDING DOORS
fix the beveled half-flange on the fixed van body and the other one on
the sliding door ;
9
Fix the 6 M4 long screws;
In case of thin sheets (max 2.5 mm) fix the 6 M4 short screws into the
rivets that you have inserted (see step 6).
CAUTION
if the surface is irregular, use the plastic shims included in the
kit (see step 2). Since some doors can be subjected to defor-
mation, it is suggested not to exceed in tightening.
Open the shutter/sliding door. Place the external shell (key not inserted)
onto the half flange in the only possible way (see
Turn the external shell of 180°
11
From the inside of the door, fix the external shell in the hole with 3,5 mm
diameter using the M3,5x14 screw and the star washer.
Close the shutter/sliding door.
HOW TO USE
Insert the key and turn it of 180°. Turn the external shell until the lock
symbols are on vertical axis. Turn the key and extract it: the lock is se-
13
cured.
• Insert the key and turn it; turn the external shell. Turn the key and ex-
tract it: the lock is NOT secured.
Opening/closing is guaranteed by the extraction of the key.
Securing is at complete discretion of the user.
Check the steadiness of the device: now you can open and close the
device. Lubricate the lock at least every three months with a specific
product. A silicone lubricant (VW G052 778 A2) is recommended.
When washing the vehicle, avoid to point the water jet directly on the
device.
Saturn Evo | Mounting instructions
;
8
).
10
;
12
9