Crown CT22033 Original Instructions Manual page 18

Torque adjustment (see fig. 4)
Press the button 6 in order to set to set one of four
torque values most suitable for the work performed
(see fig. 4.1).
The set torque value is shown by indicators 5 (see
fig. 4.2).
Battery charge state (see fig. 4)
Press and hold (at least 3 seconds) the button 6 (see
fig. 4.1).
Indicators 5 show the state of charge of the battery
(see fig. 4.3).
Recommendations on the power tool
operation
• Install accessories as described above�
• Always turn off the power tool before installing it on
the fastener� Rotating accessories can slip or damage
the slot of the fastener�
Power tool maintenance / preventive
measures
Battery maintenance instruction
• Charge timely before the battery is completely ex-
hausted� Stop operation in low power and charge it
immediately�
• Do not overcharge when the battery is full, otherwise
it will shorten the life time�
• Charge battery in the room temperature of 10°C
to 40°C (50°F to 104°F)�
• Charge battery every 6 months without operation for
a long time�
• Replace worn out batteries in time� Decline of pro-
duction or a significantly shorter runtime of the power
tool after charging indicates aging of the battery and
the need for replacement� It should be taken into ac-
count that the battery may discharge faster if the works
take place in the temperature below 0°С.
• In case of long time storage without use, it is recom-
mended to store the battery at room temperature, it
should be charged to 50%�
The manufacturer reserves the possibility to introduce changes.
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com.
Transportation of the power tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Li-Ion batteries
The contained Li-Ion batteries are subject to the Danger-
ous Goods Legislation requirements� The user can trans-
port the batteries by road without further requirements�
When being transported by third parties (e�g�: air trans-
port or forwarding agency), special requirements on
packaging and labelling must be observed� For prepa-
ration of the item being shipped, consulting an expert
for hazardous material is required�
Dispatch batteries only when the housing is undam-
aged� Tape or mask off open contacts and pack up the
battery in such a manner that it cannot move around
in the packaging� Please also observe possibly more
detailed national regulations�
Environmental protection
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging
should be sorted for environment-friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
18