Crown CT22033 Original Instructions Manual page 17

Symbol
Power tool designation
The power tool has been designed to unscrew and
to tighten threaded fastening elements (bolts, nuts,
screws, bolt screws, etc�)�
Power tool components
1 On / off switch (reverse function)
2 Body
3 LED lamp
4 Tool holder (with magnet)
5 Indicator
6 Button (torque regulator / вattery charge state)
7 USB socket (type C)
8 USB cable *
9 Magnetic holder *
10 Case *
11 Screwdriver bit *
12 Power unit *
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation of power tool
elements
Mounting / replacement of accessories (see fig. 1)
Mount / replace the accessories into tool holder 4, as
shown onto fig. 1. Attention: the tool holder 4 has a
built-in magnet, therefore it is not recommended to
install double-side screwdrivers into it. They can
not be securely fixed in the tool holder 4 due to
the small contact area of the screwdriver end with
the magnet, while the end of the screwdriver can
destroy the magnet.
Charging procedure of the power tool
battery
Initial operating of the power tool
The power tool is supplied with a partially charged
battery. Before the first use, the battery must be fully
charged.
Meaning
Attention� Important�
Useful information�
Do not dispose of the power
tool in a domestic waste
container�
Charging (see fig. 2)
• Connect the plug of USB cable 8 to socket 7 (see
fig� 2�1)� Connect USB cable 8 to suitable power
unit 12 or USB socket�
• During charging one of the indicators 5 blink and
three indicators 5 light up� When charging is complete,
all indicators 5 will light up�
• When charging is complete, unplug USB cable 8
from socket 7 and disconnect USB cable 8 from power
unit 12 or USB socket�
During charging the battery of the power
tool and power unit 12 may become hot - it
is no problem.
You can't use the power tool during
charging - it will not turn on.
Switching the power tool on / off
Rotation to the left
Press and hold the front part of on / off switch 1 ("▲",
see fig. 3.1), to switch off - release it.
Rotation to the right
Press and hold the back part of on / off switch 1 ("▼",
see fig. 3.2), to switch off - release it.
Design features of the power tool
Battery
The battery of the power tool is protected by the safety
system against deep discharge� In case of complete
discharge, the power tool is automatically switched
off� Attention: do not try to switch on the power
tool when the protection system is activated the
battery of the power tool can be damaged.
Temperature protection
The temperature protection system enables to auto-
matically deactivate the power tool in case of excess
load or when the temperature of the battery is exceed-
ing 80°C� The system guarantees protection of the
power tool from damage in case of noncompliance
with the operation conditions�
LED lamp
When the on / off switch 1 is pushed, the LED lamp 3
is automatically switched on that allows to carry out
works in low light conditions�
Changing the rotational directions (see fig. 3)
Change the direction of rotation only after
a full stop of the motor, acting otherwise
may cause damage to the power tool.
Rotation to the left (unscrewing) - press and hold the
front part of on / off switch 1 ("▲", see fig. 3.1)�
Rotation to the right (drilling, screwing in) - press and
hold the back part of on / off switch 1 ("▼", see fig. 3.2)�
English
17