Table of Contents
Advertisement
2-7. PICTURE TUBE REMOVAL
Bezel assembly
5
• REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after
removing the anode.
• REMOVING PROCEDURES
a
1 Turn up one side of the rubber cap in
the direction indicated by the arrow a.
• HOW TO HANDLE AN ANODE-CAP
1 Don't scratch the surface of anode-caps with sharp shaped
material!
2 Don't press the rubber hardly not to damage inside of anode-
caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
3 Don't turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or damage the rubber.
Picture tube
6
CN801
b
2 Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow b.
www.rtv-horvat-dj.hr
Anode cap
1
2pin
CN1
CN11
Three connectors
3
Deflection yoke
8
2-4
Four screws
4
(Tapping screw (5))
A board
2
Neck assembly
7
Anode Button
3 When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in the
direction of the arrow c.
19T2
c
Advertisement
Table of Contents
