Advertisement
Quick Links
Advertisement
Related Manuals for closomat Palma Vita
Summary of Contents for closomat Palma Vita
- Page 1 Closomat Palma Vita installation & user guide.
-
Page 2: Technical Data
The safety instructions are introduced by signal words, which express the extent of the • The Closomat toilet must not be in direct line hazard/risk. with the shower spray. Some form of partition • In order to prevent accidents, personal injury,... - Page 3 Environmental conditions • The Closomat toilet is self-sufficient but it is The Closomat toilet is rated to IPX4 and can be recommended that a competent experienced installed and operated within a typical shower/toilet Service Engineer carry out a safety check and room.
- Page 4 Palma Vita planning data and service requirements Key / Installation guide: 1. Determine unit height as standard or with optional points (P) 2. Locate floor & wall template jig to plan positions (J) 3. Locate waste pipe / soil position (S) Floor &...
-
Page 5: Installation
Installation IMPORTANT: Please retain all packaging until the installation is complete. Protect all floor surfaces when handling the Closomat. DO NOT slide the Closomat across the flooring. To lift the Closomat use the porcelain Remove the seat – Open the lid. Press... - Page 6 The provision of an isolation agent or similarly qualified persons in order to avoid a hazard. valve is always recommended Position the Closomat and place all four Secure the Closomat to the floor using Anchor the Closomat to the rear wall.
-
Page 7: Test Procedure
Douche temperature and pressure are preset at factory, and adjustments should only be carried out by Closomat engineers familiar with the equipment. note • The Closomat will not function automatically if the seat switch is not depressed. • The unit should be switched on electrically at all times when in service. -
Page 8: Finishing The Installation
Replace the seat by locating the ‘seat Complete the installation by testing the pivots’ into the seat hulls fixed to the Closomat works, by again depressing the pan – press the seat firmly to secure seat and holding in one of the elbow pads. - Page 9 Closomat. to be used for the application. Using ALL four blocks anchor the Closomat to the plinth.
- Page 10 Palma integrated fold-down support arms installation HOLE CUTTING POSITION FOR OUTER COVER Armrest IS MEASURED Left Hand TO CENTRE OF ARM BRACKET ON FRAME Stainless Pivot Bearing M20 Bolt Important Hole Bolt must not diameter rotate when the armrest is 76mm moved.
- Page 11 Closomat toilet from being located against the wall. The infill panel is available in thickness sizes 25mm, 50mm and 75mm. The infill panel is 100mm taller than the Closomat toilet. It must be cut from the bottom to suit the finished toilet height .
- Page 12 Building 1, Brooklands Place, Brooklands Road, Sale, Cheshire, M33 3SD Freephone : 0800 374 076 Telephone: 0161 969 1199 Fax : 0161 973 2711 General Enquiries: info@closomat.co.uk Sales Orders/Enquiries: sales@closomat.co.uk Quotations/ Pricing: quotations@closomat.co.uk British manufacturing British design and development British customer support We reserve the right to make modifications as a result of ongoing adjustments and further development.
Need help?
Do you have a question about the Palma Vita and is the answer not in the manual?
Questions and answers