Table of Contents
Advertisement
7.2.
Adjustment
7.2.1.
Adjustment of BDT110GA/GC/GN/GT/GW
NOTE:
Please do the adjustment according to the following steps.
7.2.1.1.
Drive OPU-QR Code write(72)
In the service mode, enter 6 digits QR Code after numeral keys
D
R
Q
D
R
Q
D
R
Q
7.2.1.2.
[Drive] Adjustment value initialization(71)
When the projector is being manufactured in the factory, the drive adjustment value is initialized.
In the service mode, enter 4 digits password (
starts.
If password is entered by mistake, it will return to initial status in the service mode (SERV_).
D
P
D
I
N
I
D
I
N
I
D
I
N
I
7.2.2.
Adjustment of BDT110PU/PX
7.2.2.1.
[Drive] Adjustment value initialization(71)
When the projector is being manufactured in the factory, the drive adjustment value is initialized.
In the service mode, enter 4 digits password (
starts.
If password is entered by mistake, it will return to initial status in the service mode (SERV_).
D
P
D
I
N
I
D
I
N
I
D
I
N
I
7.2.3.
In the Case of Necessity the Adjustment
1. When the OPU ass'y is replaced.
2. When the Drive unit is replaced.
3. When IC51301 part of Digital P.C.B. is replaced.
All manuals and user guides at all-guides.com
Enter
in service mode.
Enter the 6 digits QR code on QR label(OPU). The operation cannot be terminated until all the 6 num-
bers is entered. If "000000" is entered, QR code write mode can be unlocked.
O
K
QR code write success
N
G
QR code write failure
When a digit is entered, it is displayed in
(Enter
Input a correct password of 4 digits), then initialization is performed.
O
K
When adjustment value is initialized and auto adjustment is ended normally.
N
G
When adjustment value is initialized and automatic adjustment is ended abnormally.
When a digit is entered, it is displayed in
(Enter
Input a correct password of 4 digits), then initialization is performed.
O
K
When adjustment value is initialized and auto adjustment is ended normally.
N
G
When adjustment value is initialized and automatic adjustment is ended abnormally.
are input on the remote control.
)after numeral keys
are input on the remote control, then initialization
(4 digits) (Blank shows when no password is being input)
)after numeral keys
are input on the remote control, then initialization
(4 digits) (Blank shows when no password is being input)
26
Advertisement
Table of Contents
