Washing Programmes; Change The Programme - Samsung DMM770B User Manual

washing programmes

TURNING ON THE APPLIANCE
Starting a wash cycle...
1. Draw out the lower and upper basket, load the dishes and push them back. It is commended that
loading the lower basket fi rst, than the upper one (see the section entitled "Loading the Dishwasher").
2. Pour in the detergent (see the section entitled "Salt, Detergent and Rinse Aid").
3. Insert the plug into the socket. The power supply is 220-240 VAC 50 HZ, the specifi cation of the socket
is 12 A 250 VAC. Make sure that the water supply is turned on to full pressure.
4. Open the door, press the Power button and then display lights will turn on. Press the 'PROG' button
and option (FLEX wash, 3 in 1, or Delay start) to select a desired "Wash cycle".
(See the section entitled. "Wash Cycle Table".)
When a cycle isn't underway, you can turn off the power by a soft touch of the Power button: When a
cycle is underway, You have to hold the Power button for 3 seconds to turn off the power.
When the door is closed, any button isn't available.
5. With a little force to ensure the door is properly closed.
A click could be heard when the door is closed perfectly.
6. When the washing is over, you can shut off the switch by pressing Power button.

CHANGE THE PROGRAMME

Premise : A cycle that is underway can only be modifi ed if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already drained
the wash water. If this is the case, the detergent dispenser must be refi lled (see the entitled "Loading the
Detergent").
Open the door, Press current PROG. button more than three seconds to cancel the program, then you can
change the program to the desired cycle setting (see the section entitled "Starting a wash cycle..."). Then,
close the door.
If you open the door when washing, the machine will pause. When you close the door, the machine
will keep on working after 10 seconds.
The 6 program lights shows the state of the dishwasher when you open the door:
a) All program lights off → stand by
b) One of the program lights on → pause
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the main
power and water supply before calling a service.
Add a dish
A forgotten dish can be added any time before the detergent cup opens.
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Add forgotten dishes.
4. Close the door, the dishwasher will work after ten second.
WARNING : It is dangerous to open the door when washing, because the hot water may
scald you.
DD81-01306A-01_EN.indd Sec7:25 DD81-01306A-01_EN.indd Sec7:25
washing programmes _25
2012-09-27 2012-09-27 10:53:09 10:53:09