Washing Programmes; Turning On The Appliance; Change The Program - Samsung DW-FN320T User Manual

Washing programmes

TURNING ON THE APPLIANCE

Starting a cycle wash
1. Draw out the lower and upper basket, load the dishes and push them back..
It is recommended to load the lower basket first, then the upper one (see the section entitled "Loading
the dishwasher racks").
2. Pour in the detergent (see the section entitled "Using the detergent and water softener").
3. Insert the plug into the socket. The power supply is 220-240 VAC/50 HZ, the specification of the socket
is 15A 250VAC. Make sure that the water supply is turned on to proper pressure.
4. Close the door, press the Power button, to switch on the machine.
5. Press the Program button, the wash program will be changed as follows direction:
Intensive  Auto  Eco  Delicate  Express Wash  Pre Wash
If a wash program is selected, the response light will light. Then press the Start/Pause button, the
dishwasher begins to start.
When you press the Start/Pause button to pause during washing, the running indicator will stop
blinking and the dishwasher will beep every minute unless you press the Start/Pause button to start.

CHANGE THE PROGRAM...

Premise:
1. A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled (see the section entitled "Fill the detergent in
dispenser").
2. Press the Start/Pause button, the machine will be in standby state, press the Program button more
than 3 seconds then you can change the program to the desired cycle setting.
If you open the door during a wash cycle, the machine will pause. The program light will stop blinking
and the buzzer will beep every minute unless you close the door. After you close the door, the machine
will keep on working after 3 seconds automatically.
If your model has broken memory function, the machine will go on to finish the selected program after
the power cut.
Add a dish
A forgotten dish can be added at any time before the detergent dispenser opens.
1. Press the Start/Pause button and make sure to open the door slowly and carefully as there
is a possibility of injury from the hot steam inside the dishwasher.
2. After the spray arms stop working, you can open the door completely.
3. Add forgotten dishes.
4. Close the door. The dishwasher will work after 3 seconds.
WARNING: It is dangerous to open the door when washing, because the hot water may
scald you. If the door is opened while the dishwasher is running, a safety mechanism is
activated and stops the cycle.
22_ washing programmes