Table of Contents
Advertisement
Jubilee clip
Removing Jubilee clip
12. Pass the transducer cable through the shaft from the flange side.
13. Apply Three Bond (1104 200G:local supply) to the top side of the transducer evenly.
14. Apply Three Bond to the thread part of hex. bolt (15) with seal washer (16) and use them to
fasten the transducer.
Check that the fore mark on the shaft is aligned with the projection at the bottom of the
transducer.
15. Pass the flat washer (8), gasket (7), washer (8), and the gland (19) onto the transducer
cable.
Removing flat-head Phillips screws
Bottom view
12
Do not remove this screw.
Remove these four screws.
The fore mark on the shaft
Align them.
The projection on the transducer
Advertisement
Table of Contents
