Connecting power supply
Put the connector of the power cord
1.
into the AC (AC inlet) of the projector.
2.
outlet. In a couple of seconds after the
power supply connection, the POWER
indicator will light up in steady orange.
Please remember that when the DIRECT POWER ON function activated, the
connection of the power supply make the projector turn on.
WARNING
Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
shock or other accidents.
of the building using an appropriate power cord (bundled).
NOTICE
to-phase voltage of 220 to 240 V.
Fastening the cable
Use the supplied cable tie to fasten the cable.
10
Please use extra caution when connecting the power cord, as
Cable tie - large
AC
Power cord
Cable tie - small
Cable tie - small