Toyota Sienna 2013 Manual page 31

STEP 7
Return the wireless remote control to the AUTO ACCESS
SEAT. (P. 26)
STEP 8
Adjust the AUTO ACCESS SEAT as necessary (P. 6),
and buckle the seat belt before driving.
STEP 9
Close the right-hand sliding door.
■
Wireless remote control
●
When the seat raise switch is pressed, the beep will sound once and the
AUTO ACCESS SEAT will begin to operate. The seat will not operate if
the switch is pressed repeatedly.
●
The AUTO ACCESS SEAT will stop operating if the seat raise switch is
released during operation.
SIENNA AAS_OM45476U_(U)
1-2. Operating the AUTO ACCESS SEAT
The beep will sound once,
and the AUTO ACCESS
SEAT will begin to move
automatically
seatback reclines.
The indicator light on the wire-
less remote control will flash.
The AUTO ACCESS SEAT
will rotate while the seat-
back raises and while mov-
ing towards the rear of the
vehicle.
Once the seat has rotated fully,
the beep will sound once and
the seat will stop moving auto-
matically. Release the switch
at this time.
while the
1
31