Cleaning - Bartscher MX 235 Manual

CAUTION!
Remember to firmly tighten the blade
to the agitator shaft using a grub screw
(fig. on the right).
Deactivation
The device deactivation consists of the following operations:
1. wait for the end of processing or obtaining the required
properties of the product before deactivation,
2. stop the device by releasing appropriate button,
3. put the device on appropriate work surface,
4. remove the plug from the socket;
5. perform cleaning.

6. Cleaning

WARNING!
Disconnect the device from the power supply
(unplug!) before cleaning.
Never clean the device with use of water jet!
Be careful and do not let the water into the device.
Do not use the pressure steam washers!
Do not direct the pressurized air jet to the areas with flour
and generally towards the device.
The device must not be cleaned with use of the following products:

cleaning agents containing chlorine (also diluted) or chlorine-based, like: sodium
hypochlorite, hydrochloric acid, pipe cleaners, marble cleaners, scale removers,
etc. They may damage the steel surface and cause irremovable stains or corrosion.
Such products may become oxidized and in some cases cause pits in steel;
Grub screw
Blade
- 33 -