Advertisement
2
Installing the Block Heater Kit
Parts needed for this procedure:
1
Block heater
2
Flanged-head bolts (8 x 16 mm)
1
Heater-electrical cord
1
Cable tie
Procedure
1. Lubricate the O-ring on the block heater with 15W-40
engine oil.
2. Insert the block heater into the hole in the engine block
with the element of the heater pointing down (Figure
6).
1. Flanged-head bolts (8 x
16 mm)
2. Heater element
3. Align the hole in the block heater with the hole in the
engine block (Figure 6).
4. Secure the block heater to the block (Figure 6) with the
2 flanged-head bolts (8 x 16 mm).
5. Torque the bolts to 24 N-m (212 in-lb).
6. Connect the connector of the heater-electrical cord to
the connector of the block heater (Figure 7).
Figure 6
3. Block heater
4. Hole (engine block)
1. Connector (electrical cord) 2. Connector (block heater)
7. Route the cord over the top of the right-frame channel
of the machine (Figure 8).
1. Cable tie
2. Plug (electrical cord for the
block heater)
8. Secure the electrical cord of the block heater to the
charge cable of the alternator with a cable tie (Figure 8)
3
Figure 7
Figure 8
3. Charge cable (alternator)
4. Right-frame channel
Advertisement
