HIRED-HAND MEGA FLOW Motor Replacement

Before Installing Motor

1. Inspect motor for damage in transit. Check for
loose, missing, or damaged parts.
2. Do not operate fan until you are completely
familiar with its
INSTRUCTIONS PRIOR TO INSTALLATION.

Tools Required

Crescent wrench
3/8" Ratchet
7/16" Socket
9/32" Drill bit
36" MegaFlow Fan using Ceiling Mount
Option

MOTOR REPLACEMENT INSTRUCTIONS

1. Disconnect all Electrical power to the Fan.
2. Remove the fan from its installation position and
place the fan on a level surface. Remove both the
front and rear Wire Guards. Save the hardware for
re-installation later.
3. Remove the power cable from the motor housing.
4. Position the fan with the blades facing upward.
HIRED-HAND MFG., INC. • 1733 County Road 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
M E G A F L O W
36" (91 cm) Dairy Fan Housing
operation. READ ALL
12 point 3/8" socket
2 1/4" Hole saw
9/32" Socket
Cordless drill
Manual Part No. 4801-5159
®
M o t o r R e p l a c e m e n t
!
1. Disconnect power source before installing or
servicing fan.
source can result in property damage, serious
injury, or death.
2. When this fan is used in a life support ventilation
system where failure could result in loss or
injury, the user should provide adequate backup
ventilation, or accept the risk of such loss or
injury.

Replacement parts

Description
Motor
36" MegaFlow Fan with Post Mount
Option
5. Using a 12 point 3/8 socket, remove the fan blade.
See Figure 1.
Use a 12
point 3/8"
Socket
Figure 1 – Remove the Fan
Page 1 of 2

WARNING

Failure to disconnect power
Part No.
3017-3100
Post Mount
NOTE: Rear Guard removed