Switching On And Off - eisenblatter MINI MAX 1100 Original Instructions Manual

10.4 Use as an angle grinder
See page 3, figure E2.
Turn the additional handle (A2-2) until it is perpendicular
to the working direction. Swivel the machine 90 degrees.
10.5 Use as a drive motor for flexible shafts
( optional accessories)
See page 3, figure E3.
Fasten the flexible shaft by docking the "core shaft" on
the 6 mm collet.
Please read the enclosed operating instructions
before using the flexible shaft.
Note: The flexible shaft is particularly suitable for
working in hard-to-reach places.
www.eisenblaetter.de
Original instructions MINI MAX

11. Switching on and off

Always guide the machine with both hands.
Switch on first, then guide the accessory towards
the workpiece.
Avoid inadvertent starts: always switch the tool off
when the plug is removed from the mains socket
or if there has been a power cut.
The machine must not be allowed to draw in
additional dust and shavings. When switching the
machine on and off, keep it away from dust deposits.
After switching off the machine, only place it down when
the motor has come to a standstill.
In continuous operation, the machine continues
running if it is forced out of your hands. Therefore,
always hold the machine with both hands using the
handles provided, stand securely and concentrate.
Switching on:
Push the sliding switch (A2-3 / H2-4) forwards.
For continuous operation, now tilt it downwards until it
engages.
Switching off:
Press the rear end of the sliding switch (A2-3 / H2-4) and
release it.
1100 / MINI MAX AKKU
® ®
EN
25