Accessories; Initial Operation - eisenblatter MINI MAX 1100 Original Instructions Manual

8. Accessories

Only use original Eisenblätter CAS battery packs and
Eisenblätter accessories.
Use only accessories that fulfil the requirements and
specifications listed in these operating instructions.
8.1 Accessories power tools and cordless operated
power tools:
Art. no. Description
10010 Flexible shaft
10017 MINI MAX
10032 MINI MAX
10100 MINI FIX KLETT special backing pad
10105 Soft damping adapter
10201 MINI MAX
10202 MINI MAX
15001 PINLOC starter set
15110 PINLOC backing pad Ø 50 mm
15140 PINLOC backing pad Ø 75 mm
38663 Ball joint mount
8.2 Accessories cordless operated power tools:
Art. no. Description
50474 High-speed charging device
50463 CAS battery 5,5 Ah
50473 CAS battery 8,0 Ah
Use abrasive tools made from Eisenblätter for best work
results, such as:
• Sanding sleeves
• Sanding wheels
• Polishing tips
• Round wire wheels
• Wire brushes
• MINI FIX HOOK & LOOP quick change system
• PINLOC quick change system
• Auxiliary materials for polishing
• Chemicals and care products
Note: Accessories shown or described are not
part of the standard delivery scope of the product.
The complete program can be found on
www.eisenblaetter.de or in the catalog.
www.eisenblaetter.de
clamping shaft
®
PRO accessory set
®
expansion roller Ø 30 mm
®
expansion roller Ø 45 mm
®
Original instructions MINI MAX

9. Initial operation

Rotating additional handle:
See page 3, figure C.
The additional handle (A2-2 / H2-1) can be adjusted
5 times for different working positions. To do this, open
the grip piece until the additional handle can be moved,
turn it to the desired position and then tighten the grip
again.
9.1 For mains powered machines only:
Before commissioning, check that the rated mains
voltage and mains frequency, as stated on the
type plate match your power supply.
Always install an RCD with a maximum trip current
of 30 mA upstream.
Setting speed:
The speed can be preset via the thumb-wheel (A2-6) and
is infinitely variable.
(Small number= small speed;
high number = high speed)
Position
1
2
3
4
5
6
The VTC electronics make material-compatible work
possible and an almost constant speed, even under load.
The best way to determine the ideal speed setting is by
performing a test.
Particulate matter protection cap
Always fit the particulate matter protection cap if
the surroundings are heavily polluted.
Attachment: See page 2, figures B1 and B2.
Attach the particulate matter protection cap as shown
by pushing it over the cable on the back of the machine
and pressing it into place.
To remove: See page 2, figure B3.
Remove the particulate matter protection cap as shown.
It can be removed from the back of the machine with
light pressure.
1100 / MINI MAX AKKU
® ®
Speed
9,400 min
13,200 min
15,500 min
18,900 min
22,700 min
25,200 min
EN
-1
-1
-1
-1
-1
-1
23