Settings For The Sound (Audio Setup) - Sony DVP-NS300 Operating Instructions Manual

Settings for the Sound
(AUDIO SETUP)
"AUDIO SETUP" allows you to set the
sound according to the playback and
connection conditions.
Select "AUDIO SETUP" in the Setup
Display. For details on using the display, see
"Using the Setup Display" (page 56).
The default settings are underlined.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
xAUDIO ATT (attenuation)
If the playback sound is distorted, set this
item to "ON." The player reduces the audio
output level.
This function affects the output of the
following jacks:
— LINE OUT L/R (AUDIO) 1/2 jacks
OFF Turns off the audio attenuation.
Normally, select this position.
ON
Reduces the audio output level so that
no sound distortion occurs.
Select this when the playback sound
from the speakers is distorted.
xAUDIO DRC (Dynamic Range Control)
(DVD only)
Makes the sound clear when the volume is
turned down when playing a DVD that has
the AUDIO DRC function. This affects the
output from the following jacks:
— LINE OUT L/R (AUDIO) 1/2 jacks
— DIGITAL OUT (COAXIAL and
OPTICAL) jacks only when "DOLBY
DIGITAL" is set to "D-PCM" and
"MPEG" is set to "PCM" in "DIGITAL
OUT" (page 62).
STANDARD
TV MODE
WIDE
RANGE
xDOWNMIX (DVD only)
Switches the mixing down methods when
you play a DVD on which rear signal
OFF
components such as LS, RS, or S are
STANDARD
DOLBY SURROUND
recorded in Dolby Digital format. For details
ON
D-PCM
on the rear signal components, see
PCM
OFF
"Changing the Sound" (page 43). This
function affects the output of the following
jacks:
— LINE OUT L/R (AUDIO) 1/2 jacks
— DIGITAL OUT (COAXIAL and
DOLBY
SUR-
ROUND
NORMAL
Normally, select this position.
Makes the low sounds clear
even if you turn the volume
down. It is especially
recommended when you listen
to the sound using the speakers
of the TV.
Gives you the feeling of being at
a live performance. When you
use high quality speakers, it is
even more effective.
OPTICAL) jacks when "DOLBY
DIGITAL" is set to "D-PCM" in
"DIGITAL OUT" (page 62).
Select this when the player is
connected to an audio component
that conforms to Dolby Surround
(Pro Logic). The output signals
which reproduce the Dolby
Surround effect are downmixed to
2 channels.
Select this when the player is
connected to an audio component
that does not conform to Dolby
Surround (Pro Logic). All of the
output signals are downmixed to 2
channels without the Dolby
Surround (Pro Logic) effect.
continued
61