Connecting to a Dolby Surround (Pro Logic) decoder amplifier (receiver)
and 3 to 6 speakers
This connection will allow you to enjoy the surround effects of the Pro Logic decoder on your
amplifier (receiver). If you have an AV amplifier (receiver) equipped with a Dolby Digital,
MPEG audio, or DTS decoder, refer to page 23.
You can enjoy the Dolby Surround effects only when playing Dolby Surround audio or multi-
channel audio (Dolby Digital) discs.
Pro Logic uses a minimum of 3 speakers (front L and R, and rear (monaural)). The surround
effects are enhanced if 6 speakers (front L and R, center, rear L and R, and subwoofer) are used.
If your amplifier (receiver) has R and L audio input jacks only, use
(receiver) has a digital input jack, use
xRecommended surround sound effects using this connection with your amplifier (receiver)
Dolby Surround (Pro Logic) (page 67)
For correct speaker setting location, please refer to the operating instructions of the amplifier (receiver).
to coaxical or optical input
l: Signal flow
When connecting 6 speakers, replace the monaural rear speaker with a center speaker, 2 rear speakers and a
cord (not supplied)
Optical digital cord
Remove jack cap
Dolby Surround amplifier (receiver)
Stereo audio cord
. If your amplifier
to audio input