Page 1
DON´T TOUCH THE LED feeder position 2" 50.8mm L 48" 1219.2mm feeder position 2" 50.8mm L 72" 1828.8mm feeder position 2" 50.8mm L 96" 2438.4mm XAL Inc. 150 Hawley Rd. Oxford, CT 06478 T: +1 203.262.9990 www.xalusa.com M I -V01 4/20/21...
Page 2
3. Slide bracket(s) on top of channel 4. Use screw(s) to secure bracket(s) 5A. Use screw(s) to secure side bracket(s) ( ⁄ SLOT GRID ONLY) XAL Inc. 150 Hawley Rd. Oxford, CT 06478 T: +1 203.262.9990 www.xalusa.com M I -V01 4/20/21...
Page 3
Call the XAL After Sales Hotline from Monday to Friday, 8 AM - 6 PM (EST) Hotline: +1 203 262 9990 Or 24/7 via email: service@xalusa.com XAL Inc. 150 Hawley Rd. Oxford, CT 06478 T: +1 203.262.9990 www.xalusa.com M I -V01 4/20/21...
Page 4
3 ⅞" BASO 4 DIRECT TRIMLESS FEEDER POSITION ENDCAP WIDTH 2" 50.8mm 3/32" 2.4mm Cutout L 96" 91.5mm 2438.4mm 3 / " 122.2mm 4 13/16" XAL Inc. 150 Hawley Rd. Oxford, CT 06478 T: +1 203.262.9990 www.xalusa.com M I -V01 4/20/21...
Page 5
14. Make connections & insert inset 15. Cover should be flush to channel between segments. (continuious runs, follow steps 9-13) should hear “click” once secure XAL Inc. 150 Hawley Rd. Oxford, CT 06478 T: +1 203.262.9990 www.xalusa.com M I -V01 4/20/21...
Page 6
BASO 4.0 Turn measuring block sideways and insert into the channel. Leave spacer inside channel while screwing channel to block. XAL Inc. 150 Hawley Rd. Oxford, CT 06478 T: +1 203.262.9990 www.xalusa.com M I -V01 4/20/21...
Page 7
2" 50.8mm 3/32" 2.4mm min. 4.3mm L 96" / " 2438.4mm max. 27.2mm Cutout 1 / " 91.5mm 100.1mm 3 / " 3 15/16" XAL Inc. 150 Hawley Rd. Oxford, CT 06478 T: +1 203.262.9990 www.xalusa.com M I -V01 4/20/21...
Page 8
6. LEDs are high-quality electronic components! Please avoid touching by hand the LED light emitting surface while assemblying or replacing parts and during maintenance work. The LED circuit must always be closed, before the converter is connected to the main power. XAL does not assume any liability for damages resulting from nonobservance of this rule.
Page 9
6. LEDs are high-quality electronic components! Please avoid touching by hand the LED light emitting surface while assemblying or replacing parts and during maintenance work. The LED circuit must always be closed, before the converter is connected to the main power. XAL does not assume any liability for damages resulting from nonobservance of this rule.