Installation - Electrolux ENN2800BOW User Manual

30 www.electrolux.com
Problem
7.2 Replacing the lamp
1. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction of
the arrows.
2

8. INSTALLATION

If the advice does not lead to
the desired result, call the
nearest brand-mark service.
The appliance is equipped
with a longlife LED interior
light.
CAUTION!
Disconnect the plug from the
mains socket.
1
1
WARNING!
Refer to Safety chapters.
Possible cause
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
There is no cold air circu-
lation in the appliance.
2. Replace the lamp with one of the
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
7.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective
8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
Solution
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Make sure that there is cold
air circulation in the appli-
ance.
same power and shape, specifically
designed for household appliances.
(the maximum power is shown on the
light bulb cover).
Make sure that the light comes on.
"Installation".
door gaskets. Contact the Service
Center.