Huawei AR600 Series Quick Start Manual page 10

8 Logging In to the Router for the First Time
8.1 Using the console interface login settings
Before You Start
Install third-party terminal simulation software on the PC by referring to user manual or online help.
The password entered in interactive mode is not displayed on the screen.
Login Procedure
Step 1 Turn on the power switch on the external power supply and log in to the router after the SYS
indicator blinks once every 2 seconds (indicating that the router is running properly).
Step 2 Use a console cable to connect a PC to the console interface of the router.
Step 3 Start the terminal simulation software, create a connection, configure the connected port, and
set communication parameters as follows.
Transmission rate: 9600
Data bit (B): 8
Parity bit: None
Stop bit (S): 1
Flow control mode: None
Step 4
Press Enter until the following information is displayed. (The following information is only for reference)
NOTE
In V300R019C00 and later versions,
admin@huawei.com.
In versions earlier than V300R019C00, the default user name is admin and the default password is
Admin@huawei.
Login authentication
Username:admin
Password:
Info: The entered password is the same as the default. You are advised to change
it to ensure security.
After successful login, you can configure the router on the command line interface. For more information, see the
CLI-based Configuration of the product.
8.2 Using the web login settings
Before You Start
If the web page is displayed abnormally, the browser version may be too low. Upgrade the browser
and log in to the web platform using Mozilla Firefox 12.0 or later, Google Chrome 23 or later, or
Internet Explorer 8.0 or later.
The login page varies according to version.
the default user name is admin and the default password is
9