Ferax BHD-710 Manual

Lmpact drill
Hide thumbs Also See for BHD-710:

Advertisement

Quick Links

1 nstruktionsbok
Manual
Slagborrmaskin
lmpact drill
BHD-710
Code no. 19694-1009

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BHD-710 and is the answer not in the manual?

Questions and answers

Summary of Contents for Ferax BHD-710

  • Page 1 1 nstruktionsbok Manual Slagborrmaskin lmpact drill BHD-710 Code no. 19694-1009...
  • Page 2 ENGLISH 2. TECHNICAL SPECIFICATION Voltage ........V Original instructions Frequency ......... Hz CONTENTS Input power ....... W No load speed ...... r/min 0 - 2 300 Introduction ..........22 Weight ........kg Technical specification ......22 Lpa (sound pressure) ...dB(A) 95.5 + 3 Contents of packing ......22 Lwa (sound power) .....dB(A) 106.5 + 3 Features ..........22...
  • Page 3 7. Switch lock • For long hair, wear hair protection. Work 8. Speed control wheel only with closely fitting clothes. • Be aware when drilling into walls: damaging electric lines, gas lines or water lines can cause dangerous situations! Use appropriate detectors to determine if utility lines are hid- den in the work area.
  • Page 4 the machine to mains: 1. Concrete/masonry (Hard metal) • Open and close the chuck with the chuck key. 2. Metal (HSS) • By placing the chuck key in one of the three 3. Wood (HSS) holes in the chuck, the chuck can be opened 7.2 The On/Off switch by turning the chuck key counter clockwise and closed by turning the chuck key clock- wise.
  • Page 5 7.6 Switch for percussion drilling 8.1 Maintenance The machines have been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory opera- tion depends upon proper machine care and regular cleaning. 8.2 Cleaning Regularly clean the machine housing with a soft cloth, preferably after each use.
  • Page 6 BHD - 710 DIAGRAM...
  • Page 7 BHD - 710 PART LIST No. Description Specification Qty No. Description Specification Qty Screw left M6 × 25 Inner wire 0.5 × 210 Chuck Brush holder Output spindle Brush Steel ball Cross Screw ST2.9 × 12 Bearing 6001 Rotor Circlip Bearing Washer I Stator...
  • Page 8 ��)¡ ,- ,.,. a..:' l'& � lmpact drill BHD-710 ARETE SUPPLIES S.L. www.aretesupplies.com...

This manual is also suitable for:

19694-1009

Table of Contents